DIY Anti-Slip Treatment Solution

Transforming slippery to Slipfree
The solution is specially formulated to create micro-alteration to the treated surface that is invisible to the naked eye. Treatment increase floor tile traction on wet floors so as to reduce slippery surfaces.

WHERE TO USE:

This anti-slip solution can only be applied on MINERAL floor surface such as ceramic, porcelain, terrazzo, mosaic, stone, concrete, quarry and other similar mineral tiles.
NOTE – DO NOT USE IT ON NON-MINERAL SURFACE

DIRECTIONS:

  1. Clean and dry the surface to be treated. Spread solution on surface with a sponge or brush. Make sure surface remains wet with solution throughout the 10- 12 minutes of treatment.
  2. Work on the surface with sponge or brush every 2 minutes for 10 – 12 minutes.
  3. Rinse and clean treatment surface thoroughly with water to remove solution.

CAUTION:

Protective equipment (rubber gloves, boots, eye shield, face-mask) should be worn to avoid direct contact with chemical.
Keep out of reach of children at all times.

WARNINGS:

Discolouration and/or loss of shine may occur especially on glazed surface, polished surface, shiny tiles, dark coloured tiles. Treatment is irreversible, always test product for discoloration/satisfaction in a small inconspicuous area to ascertain if the result is acceptable before proceeding. Slipfree is not liable for any form of compensation, return or refund.

*No treatment can fully eliminate the risk of slip and fall, please remain cautious when walking on wet surface at all time.

U.P $48 Now $38

U.P $48 Now $38

Transforming slippery to Slipfree
The solution is specially formulated to create micro-alteration to the treated surface that is invisible to the naked eye. Treatment increase floor tile traction on wet floors so as to reduce slippery surfaces.

WHERE TO USE:

This anti-slip solution can only be applied on MINERAL floor surface such as ceramic, porcelain, terrazzo, mosaic, stone, concrete, quarry and other similar mineral tiles.
NOTE – DO NOT USE IT ON NON-MINERAL SURFACE

DIRECTIONS:

  1. Clean and dry the surface to be treated. Spread solution on surface with a sponge or brush. Make sure surface remains wet with solution throughout the 10- 12 minutes of treatment.
  2. Work on the surface with sponge or brush every 2 minutes for 10 – 12 minutes.
  3. Rinse and clean treatment surface thoroughly with water to remove solution.

CAUTION:

Protective equipment (rubber gloves, boots, eye shield, face-mask) should be worn to avoid direct contact with chemical.

Keep out of reach of children at all times.

WARNINGS:

Discolouration and/or loss of shine may occur especially on glazed surface, polished surface, shiny tiles, dark coloured tiles. Treatment is irreversible, always test product for discoloration/satisfaction in a small inconspicuous area to ascertain if the result is acceptable before proceeding. Slipfree is not liable for any form of compensation, return or refund.

*No treatment can fully eliminate the risk of slip and fall, please remain cautious when walking on wet surface at all time.

NOTICE:

The Vendor of this product makes no representations as to the effectiveness of this product in preventing slips and falls. Slips and falls could occur in many and various diverse situations and you are advised, even when using this product and our treatment, to exercise care when walking on wet surfaces at all times and to take other measures to prevent slips and falls.

The aim of this product is to increase floor tile traction on wet floors so as reduce slippery surfaces. There is no assurance given by us whatsoever that the use of the treatment or product could prevent slips or falls.